VANDERSTEEN 3A - MONO-WIRE CONNECTIONS

The performance of the Model 3As is compromised by a mono-wire connec-
tion. They should be bi-wired as soon as possible._
Bare wires should never come into
contact with the aluminum dress
plate while the amplifier is on.
Amplifier damage could result.
V__ J
The input screws should be snug,
but should not be overtightened.
Mono-Wire Connections
Mono-wiring should only be used with the Model
3As as a temporary connection method. The speakers
should be bi-wired as soon as possible.
1. Cut two sections of wire about 2Vfc inches long to
make two jumper wires.
2. Crimp and solder spade lugs to all four ends of the
two jumper wires.
3. Connect one end of a jumper wire under the top left
terminal screw and one end of the other jumper wire
under the top right terminal screw.
4. Crimp and solder spade lugs to the speaker ends of
the cable from the amplifier.
5. Connect the ground side of the speaker cable and
the jumper cable from the top left terminal screw
under the lower left terminal screw.
6. Connect the positive side of the speaker cable and
the jumper cable from the top right terminal screw
under the lower right terminal screw.
7. Connect the speaker cables to your amplifier, ground
to ground and positive to positive.
For Better Sound
a. The speaker cables should as short as possible and
the same length. Consider putting the amplifier
between the speakers rather than off to one side.
b. Use quality cables. Keep all connections clean and
tight.
c. Bi-wire or bi-amplify as soon as possible for optimum
performance.
5
Model 3A Operation Manual