vanEE 40E 44262 - Page 6

6
FILTER MAINTENANCE INDICATOR
This indicator, located in upper right corner of the wall control, illuminates
when it is time to perform the ventilation unit filter maintenance.
Once the filter maintenance is done, reset the filter maintenance indicator
as follows:

SET
MODE
PREF

BOTH DURING
5 SEC.
Press simultaneously on both Mode/Pref key and SET key
for 5 seconds to turn off the filter maintenance indicator.
HOW TO SET PREFERENCES
In order to benefit from all of the features of your wall control, the preferences must be set. Table
below shows all available settings.
SETTING AVAILABLE VALUES DEFAULT OPTION
CURRENT DAY MON/TUE/WED/THU/FRI/SAT/SUN MON
HOUR DISPLAY 12:00
AM
OR 24:00 12:00
AM
CURRENT HOUR FROM 0 TO 12 OR 24 12
CURRENT MINUTE FROM 00 TO 59 00
TEMPERATURE UNIT °C OR °F °C
INDOOR TEMPERATURE DISPLAY ON OR OFF ON
MINIMUM OUTDOOR TEMPERATURE
FOR
AIR EXCHANGE*
-40°C TO 0°C OR
-40°F TO 32°F
-25°C OR
-13°F
MAXIMUM OUTDOOR TEMPERATURE
FOR
AIR EXCHANGE*
1°C TO 40°C OR
33°F TO 104°F
27°C OR
81°F
*IN PROG OR SMART MODE, THESE LIMIT VALUES ALLOW TO STOP AIR EXCHANGE WITH THE
OUTDOOR FOR BETTER COMFORT IN THE HOUSE.
BACKLIGHT COLOR BLUE OR GREEN BLUE
BACKLIGHT DISPLAY AUTO OR ON AUTO
AUTO: B
ACKLIGHT ACTIVATED 10 SECONDS WHEN ANY KEY IS PRESSED.
ON: BACKLIGHT ALWAYS ON.
OFF MODE FOR INTERMITTENT MODE VENTILATION/RECIRCULATION
OR
VENTILATION/OFF
VENT/RECIRC.
AFTER A VENTILATION PERIOD, DETERMINES THE SECOND PA RT OF THE CYCLE
(RECIRCULATION OR OFF).
PM PM
2.2 Platinum Main Control (cont’d)
2. Controls (cont’d)
POWER INDICATOR
This indicator, located in upper left side of the wall control, illuminates
when the control is powered on.