Troubleshooting/FAQ
22
8. Troubleshooting/FAQ:
NexStar LX External 3.5” HDD Enclosure:
Q. What should the jumper settings on my hard drive be set to?
A. We recommend the hard drive be set to MASTER.
Q. My computer recognizes the NexStar LX, but it does not assign a drive letter to it.
A. You are probably using a brand new hard drive. If not, then your computer may not
be able to recognize the partition on the hard drive because it is damaged or not a
valid format. Please refer to the section “Creating A New Partition” for information on
how to create a useable partition on your drive.
Q. My computer sometimes recognizes the NexStar LX, but sometimes gives me errors.
A. If your computer is giving you problems with the NexStar 3, be sure to connect the
USB cable to a rear port, directly off the motherboard or USB PCI card. The cables
connecting front USB ports are not always properly shielded and cannot properly
handle USB 2.0 speeds, thereby corrupting the signal between the NexStar LX and
the computer.
Q. Why is the data on my hard drive corrupted?
A. Connecting your hard drive to the NexStar LX is just like connecting a hard drive to
the inside of your computer. The NexStar LX itself will not corrupt your data. If your
data has become corrupt, it is likely caused by the removal of the NexStar 3 while
data was still being written to the hard drive. CAUTION: Never remove the NexStar 3
while data is being written to the hard drive! Doing so may cause the hard drive to
become corrupt. Make sure all applications being run off the disk and all files in use
are no longer in use before removing the unit.
Q. Why is my computer not showing the full size of my hard drive?
A. If you are using Windows 98SE, please refer to Microsoft’s Windows 98 Support
Center and download the large capacity drive patch. Else, verify that your mother-
board supports large capacity drives. Some older motherboards cannot use drives
larger than 137 GB. If Windows XP/2000 will not let you create a partition larger than
32GB, make sure you are using the NTFS file system, as Windows XP/2000 limits
FAT32 partitions to only 32GB.
Otherwise, check your hard drive jumper settings. Most hard drives feature a setting
that limits the size of the drive for compatibility reasons. Make sure you have not set
the hard drive to this setting. Also, try setting your drive setting to Cable Select.
To Next Page
Loading...
Need help?
General
