Vantec NexStar MX - RAID Mode Selection; Individual Mode

9.RAID Mode Selection:
Jumper Selection & Storage Policy Definitions
Individual Mode
：
It enables each hard drive to be seen separately as single drives. When using a SATA host controller,
Individual should only be used if the SATA host controller provides “Port Multiplier” support. If the host card
does not support Port Multiplier, only a single drive will be present. No such limitation if using a USB host
connection.
15
Volume A
Drive
A
Drive B
NST-400MX-SR
Port 0 Port 1
Drive
A
Unequal hard drives
Drive B
NST-400MX-SR
Port 0 Port 1
Volume BVolume A Volume B
Equal hard drives
RAID Mode Selection