- 8 -
3.6 Rearview Camera Installation
3.5 Interior Camera Installation
Take out the interior camera and plug it into the docking
station headphone jack, then stick it on the front windshield.
There are two ways to install the rear camera, one is installed
inside the car, and the other is installed outside the car.
In-car installation: Select the installation position on the rear
windshield after installing the rear camera mount; then fix
the rear camera in the selected position and adjust the lens.
Installation outside the car: Use a trim removal tool to pop
out tailgate trim, then runs the cable from the outside of the
car into the trunk of your car. Then connect the rear
camera’s power cable to the extension cable. Finally, find
the best location, and fix the camera with a sticker or a
screw at the rear end of the car, normally the best place is
above the number plate.
ENEN
To Next Page
Loading...
