- 15 -
4.6 Resolution
4.7 Loop Recording
After inserting the memory card and connecting the power
supply, the M3 dash cam will auto turn on and enter the
loop recording.
When recording, the icon in the middle of the video
interface flashes, and the recording time will be recorded
according to the loop recording time you set. If you are
back to the screensaver screen, you can view the recording
status icon in the lower right corner of the screen to learn
about the current recording status. (The red icon means
recording is in progress, the orange icon means event
recording, and white the icon means recording has been
paused.).
1.
2.
Note:
The cabin camera will automatically switch to IR infrared
mode at night and in poor light environments.
The frame rate of the interior and rear lens are both 25FPS.
By default (Front+ Cabin+ Rear recording mode), both
cameras will capture road front and rear and cabin at
1440P+1080P+1080P.
It can be switched to Front+Rear mode with the following
steps:
-Go to “Record Setup”> “Resolution” to select Recording
Mode.
Front+Cabin+Rear Mode: 1440P+1080P+1080P;
1080P+1080P+1080P;
Front+Rear Mode: 1944P+1080P; 1440P+1080P; 1080P+1080P.
9-1
Fri
1080P+1080P1944P+1080P 1440P+1080P
1440P+1080P+1080P 1080P+1080P+1080P
EN
EN
EN
EN
To Next Page
Loading...
Need help?
General
