Vantrue Nexus 4 Pro - Page 26

- 23 -
After parking, wait for 5 minutes to enter automati-
cally;
long press the button to begin manually;
Connected to the ACC Hardwire Kit cable, the camera
will enter parking mode immediately after turning o
the engine. (ACC cable is an optional accesso, need
to buy extra).
1.
2.
3.
OK
Parking Mode
Collision Detection
Motion Detection
Low Bitrate Mode
Low Framerate Mode
To ensure the camera works properly in park mode,
please use the hardwire kits or other stable and
continuous power supply to power the dash cam.
Please use Vantrue hardwire kit for ACC hardwire,
ACC hardwire kit from other brands may not work.
If the dash cam is in an extremely hot environment,
we recommend selecting the collision detection
mode. When the temperature inside the vehicle is up
to 60°C(140°F), we recommend turning o the
camera to avoid improper operation of the camera
caused by high temperature.
Time-lapse video recording and parking mode
(including collision detection, motion detection, low
bitrate recording, and low framerate mode) can only
be enabled one at a time. When one is enabled, the
other will be automatically disabled.
All videos recorded in parking mode(Collison
Detection, Motion Detection, Low Bitrate Recording,
Low Framerate mode) will be saved in the normal
video folder. In order to prevent the video in parking
Note：
If parking mode is on, there are three ways to sta
parking mode recording:
•
•
•
•
•
monitoring modes according to dierent parking
situations.