Vantrue OnDash N4 - Page 20

With a memory card inserted, the camera will (by default) immediately
start loop recording video when connected to a power source and
powered ON. If the device is not connected to a power source, it will not
immediately start on and record.
While recording, the Record indicator will blink and a red dot will flash on
the lower corner left of the screen. You can stop/start the recording at
any time by pressing the button.
- 16 -
In three way or two-way recording mode, you can press the button to
switch display so the rear/inside camera shows bigger on the lcd.
4.5 Switch the Front, cabin and rear camera window display
FrontCameraBiggerInsideCameraBiggerRearCameraBigger
3
1440P+1080P+1080P
01-01-2021
3
1440P+1080P+1080P
01-01-2021
3
1440P+1080P+1080P
01-01-2021
4.6 Loop Recording
01-01-2021
3
1440P+1080P+1080P
By default, the Loop Recording Time is 3 minutes. Please go to “Record
Setup” > “Loop Recording” to change it to 1 min, 3 mins, or 5 mins for
your need.