24
ALL HARDWARE COMPONENTS
Visually inspect all hardware components.
SLIDING TUBES
Clean weekly with a mild soap and water solution. Lubricate with a
wet silicone lubricant.
PEDALS
Inspect pedals for broken bindings and tightness.
FLYWHEEL
Inspect weekly for noise and damage.
TOUCHSCREEN MOUNT
Inspect weekly, tighten as needed to secure.
SEAT CLAMP
Inspect weekly, tighten as needed to secure.
Weekly
BIKE
With a soft, slightly damp cloth, wipe down the bike using a mild soap
and water solution or a mild cleaner. Do not use products containing
ammonium chloride.
TOUCHSCREEN
Use a soft, slightly damp, lint-free cloth (like dry anti-static or
microfiber) to gently wipe away smudges and fingerprints. Spray a
small amount of screen cleaner or water on the cloth if necessary.
Never spray the screen cleaner solution directly onto
the touchscreen.
BEFORE EACH RIDE
Ensure cleats are secured tightly to shoe soles.
Daily
Annually
PEDALS
For maximum performance and safety,
replace the pedals every year.
BOTTOM BRACKET
Inspect bottom bracket for tightness.
POWER METER BATTERY
Check and replace power meter batteries (see pages 25-26).
CRANK BOLTS
Check crank bolt torque.
(Torque to 52-57 Nm or 38-42 lb – ft).
FRONT AND REAR STABILIZER FEET
Inspect monthly, tighten as needed to secure.
PEDALS (CLEAT TENSION)
Check cleat tension using a 4mm hex key.
Monthly
To Next Page
Loading...