25
Gen. 2
Stages indoor Power meter
Gen. 3
Stages indoor Power meter
Your bike comes equipped with either a gen. 2
or gen. 3 Stages Power meter. Both use (2) AA
batteries, good for around 2000 hours of riding
time. Identify which one you have, and follow the
corresponding directions to replace batteries.
POWER METER BATTERY
REPLACEMENT
GEN. 2
Unplug the bike before performing
any replacement.
Locate the power meter on the left side crank arm.
Remove battery cover screw using a Phillips #0
screwdriver.
Slide out the old batteries by rotating the crank
arm downward.
Open the battery door and insert batteries.
Close the battery door and tighten screws until
secure. Do not overtighten as this may damage
the battery case.
To Next Page
Loading...