Varta EASY BLADE - Easy Block; Included in the Box; Additional Systems Requirements

14
6.2 Easy Block
6.3 Included in the box
Two module connectors (including the two screws) will be delivered together with the battery. (see 7.1)
6.4 Additional systems requirements
a. Power cable
Power cables are not provided by VARTA as requirements differ in all use cases. These are available
from our distributors. See contact details on page 7. VARTA recommends using an M6 screw type for
the negative terminal and an M8 screw type for the positive terminal. For connection of the modules an
additional bus bar or wires with cable lug are needed.
b. Communication cable
The communication cable is not provided by VARTA. These are available from our
distributors. See contact details on page 7. VARTA recommends to use Tyco
Amphenol LTW 12-05BMMA-SL8001 or similar.
c. CAN termination resistor
The CAN termination resistor is not provided by VARTA. These are available from
our distributors. See contact details on page 7. VARTA recommends using Phoenix
Contact 1507816 or similar.