Vaughan Junior - Standard Model Assembly; Standard Irrigator Assembly Steps

Standard Irrigator Assembly
Attach wheels to back axle using the M16 nuts and bolt supplied.
Place axle in back of the irrigator make sure it is central (drilled holes are not central in axle). Put
front wheel on.
Place inlet ange on axle bots using a washer as a spacer if required, between the ange and back
of irrigator and screw arms in tightly using plumbing tape.
Insert riser in the inlet ange and bolt to the back of the irrigator. Make sure the riser can turn
freely. If not adjust spacers.
Support rods are bolted to the at on top of riser and brackets on the arms. Tighten rods so as to
slightly lift the arms taking the pressure o the threads.
The outer arms should be set at about 45, then varied up to slow down or down to increase rotation
speed.
The hydrant should be in the centre of run (see page ?), attach layat to the back of irrigator with
the camlock and the other end of the layat connected to the water supply with a gentle loop of at
least 2 metres radius to stop kinking.
A full rotation should take between 4 to 5 seconds regardless of water volume and pressure, and
turning in a clock wise motion.
Standard Assembly