Travel Speed Adjustment
The speed of the irrigator is determined by the “R” clip in one of the four, or ve (depending which
model), holes in the base of the irrigator, which is located at the bottom of the pivoting mechanism.
The hole closest to the back axle represents one tooth on the cog and the 4th hole 4 teeth. E.g.
3.71lps / 3,000 gph with 1 /2” nozzles should be set on the second hole (two teeth). This cycle takes
approximately 6 hours and puts out approximately 15.4mm or .61inches of water.
Once the travel speed has been selected lift both the front and back pawls away from the cog.
Run your cable out to the desired length and anchor to a solid object. (A star picket at an angle will
suce normally)
Return to your irrigator and make sure the small front pawl is rmly locked into the cog and take up
any slack in the cable.
Warranty Registration
To Next Page
Loading...