138 Driving and operating
If the vehicle is moving too fast P is
not engaged.
Reverse mode R
To engage or disengage R, the
vehicle must be at standstill and the
brake pedal has to be depressed.
Caution
Engaging R while the vehicle is
moving forward could damage the
automatic transmission. Only
select R after the vehicle has been
stopped.
Neutral modeN
In this mode, the propulsion system
does not transfer torque to the
wheels.
Automatic mode D
Notice
In slippery conditions, operate the
vehicle in D for enhanced riding and
handling performance.
This mode is for normal driving.
Automatic mode B with one-pedal
driving
In this mode, vehicle speed is
significantly reduced by releasing the
accelerator pedal without operating
the brake pedal.
Use B when driving down steep hills,
in deep snow, in mud or in stop-and-
go traffic.
9 Warning
In the case of extreme
temperatures or if the high voltage
battery is almost fully charged, the
brake force of the regenerative
braking may be temporarily
reduced. If the braking force is not
sufficient, the driver has to be
prepared to use the brake pedal.
To activate B, select D and press
button B.
To deactivate B, press button B.
Regenerative braking 3 150.
Free wheeling / car wash mode
In certain situations, e.g., in an
automatic car wash etc., it is
necessary that the wheels can move
freely when the engine is switched off.
To enable free wheeling, the vehicle
has to be stationary, the engine has
to be running and the driver's door
has to be closed.
To Next Page
Loading...
