156 Driving and operating
Adopting speed by the speed limit
recognition
A detected speed limit can be used as
new set speed for the speed limiter.
To detect speed limit signs, the traffic
sign assistant has to be activated.
Traffic sign assistant 3 181.
When passing the speed limit sign
OK? is automatically displayed.
Press OK on the steering wheel to
store the suggested speed.
The suggested speed is shown as
new speed setting.
After passing the speed limit sign
Press OK on the steering wheel.
OK? is displayed.
Press OK to store the suggested
speed.
The suggested speed is shown as
new speed setting.
Exceeding the speed limit
In the event of an emergency, it is
possible to exceed the speed limit by
depressing the accelerator pedal
firmly to the final point. In this case,
the preset speed value flashes.
Release the accelerator pedal and
the speed limiter function is
reactivated once a speed lower than
the limit speed is obtained.
When exceeding the preset speed is
not caused by depressing the
accelerator pedal, e.g., when driving
down a steep slope, an audible signal
is given.
9 Warning
On a steep descent or in the event
of sharp acceleration, the speed
limiter will not be able to prevent
the vehicle from exceeding the
preset speed. If necessary,
depress the brake pedal to control
the vehicle's speed.
Deactivation of the functionality
Press ", speed limiter is in pause
mode and a message is displayed.
The vehicle is driven without speed
limiter.
Speed limiter is deactivated, but not
switched off. Last stored speed
remains in memory for later speed
resume.
Resume limit speed
Press ", the stored speed limit will be
obtained.
Switching off the system
Press ., the speed limiter mode is
deselected and the speed limiter
screen is hidden from the Driver
Information Centre.
Fault
The speed limit recognition may not
operate correctly if traffic signs do not
comply with the Vienna Convention
on Road Signs and Signals.
To Next Page
Loading...
