176 Driving and operating
Front view
The area in front the vehicle is
displayed in the screen. The vertical
lines represent the width of the
vehicle with mirrors unfolded. The
direction of the lines changes with the
steering angle.
The first horizontal line represents a
distance of about 30 cm beyond the
edge of vehicle's front bumper. The
upper horizontal lines represent
distances of about 1 m and 2 m.
This view is displayed automatically
or can be chosen from the left side of
the screen.
Panoramic view
The panoramic view facilitates
leaving a parking bay, making it
possible to see the approach of
vehicles, pedestrians and cyclists.
This view is not recommended for
carrying out a complete manoeuvre.
This view can only be selected from
the left side of the screen.
Side view
This view allows to view the
surroundings, e.g. a pavement, a low
wall, the vehicle parked to the next
etc. on the left-hand or right-hand side
of the vehicle.
Select the standard view and touch
the required side of the vehicle. The
selected side is highlighted and the
side view is displayed.
Zoom view
The zoom view cannot be selected. It
is only displayed if the distance
between the vehicle and the obstacle
is less than 60-80 cm.
The zoom provides a view from above
the rear or the front of the vehicle in
its near surroundings.Thus, the
vehicle can be manoeuvred around
obstacles nearby.
The automatic display of the zoom
view can be disabled in the Info
Display:
Press _ below the Info Display and
select Panoramic camera.
Press :.
Activate View Adaptation.
The setting is memorised when the
ignition is switched off.
Settings
The following settings can be
adjusted:
● volume of the audible signal
● brightness
● contrast
Deactivation
Panoramic view system is
deactivated when:
● driving faster than 10 mph in
forward gear
● by pressing the icon X in the left
upper corner of the touch screen
System limitations
Caution
For optimal operation of the
system, it is important to keep the
lenses of all cameras always
clean. For the rear view camera,