186 Vehicle care
2. Remove the protective cover.
3. Turn the bulb anticlockwise and
pull straight back.
4. Disconnect the wiring harness
connector from the bulb.
5. Install the new bulb in the
headlight assembly by turning
clockwise.
6. Reconnect the wiring harness
connector.
7. Install the protective cover.
For the driver side, reinstall the
windscreen washer bottle filler neck
by firmly pushing it straight into the
bottle. Ensure that the filler neck clip
engages into the underhood electrical
centre retainer.
Uplevel headlight assembly
The uplevel model vehicle has LED
high beam and low beam headlights,
a turn and lane-change signal, a
sidelight and daytime running lights
on the headlight assembly.
Fog lights
The bulbs are accessible from the
underside of the vehicle
1. Turn the respective wheel inside
to get better access and remove
three torx screws on outside of
wheel house. Vehicle tools
3 194.
2. Pull and hold lining to get access
to the bulb holder.
To Next Page
Loading...
Need help?
General
