Assembling your upright
Place the lift out cylinder
onto the back panel
and oorhead.
Place the 3-in-1 tool
onto the storage clip.
In a hinge like manner
push the lift out cylinder
backwards until it clicks
into place.
Push the handle with
extension tube into the
back panel of the vacuum
cleaner. The handle will
click into position when
correctly tted.
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Getting started
Before you begin cleaning
WARNING: Always switch o the vacuum cleaner before connecting or disconnecting the lift out cylinder/ hose/attachments
or removing and emptying the dirt container.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat
the thermostat will automatically turn the vacuum cleaner o. If this happens switch the vacuum cleaner o and unplug from
electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. If the vacuum cleaner
is blocked, switch o and unplug before removing the blockage. Allow the vacuum cleaner to cool for approximately 1 hour
(if you have cleaned the lters please wait 24 hours for the lters to fully dry before putting back into the machine).
For best cleaning results, lters should be tapped over a bin every 4-6 uses to remove dirt and debris and washed every
3 to 6 months (depending on the level of use).
To Next Page
Loading...
Need help?
General
