Using your machine
How to use
Pull the connection cord out
of the appliance. Insert the
plug into a mains socket.
If the red marking is visible, retract the connection cord
by pressing the cord rewind button to pull in the cord
up to the yellow mark.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the
thermostat will automatically turn the unit o.
Connect the required
accessory to the handle or
the telescopic tube. Make
sure that the accessory is
securely connected.
For hard oors, only use
the combination oorhead
with the brush extended, as
the hard oor may become
damaged.
Using accessories
CAUTION: If using the TurboTool, make sure that the surface can withstand the rotating brush roller without
becoming damaged.
To Next Page
Loading...
