13
To remove any threads or hair, slide
the blade of a pair of scissors into the
groove on the brushbar and cut along
the groove.
IMPORTANT: If the brushbar or brushroll has been obstructed, the motor protection sensor may
activate. The brushes will stop and the light on the powered floorhead will illuminate red. Switch off
the machine, clear any obstruction and wait 1 minute before reactivating.
NOTE: For best performance and to reduce hair and dirt build up, remove and clean the brushbars
every 1-2 months (depending on the level of use).
Pull the brushbar out from the
brush housing.
Clear any dirt/debris from the end caps
and inside the brush housing.
Using a coin, push and turn the
brushbar cover anticlockwise to the
unlock symbol.
Refit the brushbar into the floorhead.
Align the arrow on the brushbar cover
to the unlock symbol, push firmly until
the cover sits flush and turn to
lock into place.
Cleaning and maintenance
Removing and cleaning the powered floorhead brushbar
To Next Page
Loading...
Need help?
General
