14
Use a damp cloth to remove any
dirt/debris from the brushroll.
Allow the brushroll to fully dry before
assembling back into the powered
floorhead. DO NOT wash or over
saturate the brushroll.
Check the powered floorhead inlet for
any blockages and use a blunt object to
remove the blockage.
Clear any dirt/debris inside the
brush housing.
Refit the end cap onto the brushroll. With the lock in the unlocked position
slot the brushroll into the right side of
the powered floorhead first and push
the end cap into place.
Using a coin, turn the brushroll cover
clockwise. The cover will sit flush to the
floorhead when locked into place.
Pull to remove the end cap and slide
any hair and threads off the
end of the brushroll.
Using a coin, push and turn the
brushroll cover to the unlock symbol.
NOTE: The brushroll cover cannot be
removed.
Hold the tab and pull away the
brushroll from the brush housing.
Cleaning and maintenance
Removing and cleaning the powered floorhead brushroll
To Next Page
Loading...
Need help?
General
