15
Pull the brushbar out from the
brushbar housing.
Using a coin, turn the brushbar lock
to the unlock symbol to release the
brushbar.
To remove any threads or hair slide
the blade of a pair of scissors into the
groove on the brushbar and cut along
the groove. Clear any dirt/debris inside
the housing of the floorhead.
IMPORTANT: If the brushbar in the mini motorised pet tool has been obstructed, the brushbar motor
protection sensor may activate and the brushbar will stop. Switch off the machine, remove the
tool from the reach wand/handheld/powered hose and clear any obstruction. Wait 1 minute before
refitting the tool, switch the machine on and press the brushbar ON/OFF button.
Check the inlet for any blockages
and use a blunt object to remove
the blockage.
Refit the brushbar and turn the brushbar lock clockwise to lock.
Cleaning and maintenance
Removing and cleaning the mini motorised pet tool brushbar
To Next Page
Loading...
Need help?
General
