13
Using the pre-treatment wand
Pre-treating your carpet before washing will help to remove stubborn stains. Do not saturate your carpet.
Push the wand connector
into the solution tube port.
Press and hold the trigger
on the pre-treatment
wand, spraying evenly over
stubborn stains.
Leave the solution for 10-15
minutes before washing
the carpet.
Pour the required amount
of pre-treatment solution
into the tank.
Fill the clean water tank
with warm water
(max 40°C).
Turn the rinse/wash dial
to WASH.
Open the hose connection
port cover.
Washing hard floors
CAUTION: To prevent damage to wood floors and other hard floors, follow the flooring manufacturer's cleaning
recommendations. Inspect the floor surface for a worn finish, bare wood or separated joints. It is not recommended to use
the machine on floors if any of these conditions exist. Test on an inconspicuous area first.
IMPORTANT: Hard floors should be dry vacuumed thoroughly before washing.
Before attaching the hard floor squeegee onto the machine, either remove the tanks or make sure the tanks are empty before
lying the machine on its back.
Lie the machine on its back
and line up the squeegee
with the nozzle.
Hold the front of the
squeegee onto the edge
of the nozzle and push the
squeegee under the nozzle
until it clicks into place.
USING YOUR MACHINE
Plug the machine into the
mains and press the On/Off
pedal to switch on.
Pour the required amount
of solution into the tank.
Fill the clean water tank
with warm water
(max 40°C).
To Next Page
Loading...
