12
USING YOUR MACHINE
Turn the rinse/wash dial
to WASH.
Open the hose connection
port cover.
Push the hose end and hose solution
connector into the hose connection port.
To remove the hose press
the hose release clip on
the end of the hose and
pull to remove.
Plug the machine into the
mains and press the On/Off
pedal to switch on.
Select the SpinScrub or Wash tool. Slide the tool over
the tab at end of the hose until it clicks into place.
Press the trigger on the
forward stroke to release
water/solution.
Release the trigger on the
backward stroke to pick up
water/solution. For a dryer
finish continue using dry
strokes (trigger released)
until little water is visibly
passing through the tool.
Using the hose and tools
IMPORTANT: The machine should be in the upright position when using the hose and tools; this will de-activate the brushes. To
avoid saturating the carpet, do not use more than 4 wet strokes over any one area. Always end with dry strokes (trigger released).
SpinScrub Tool
Suitable for targeting
stains and stubborn marks
on rugs and carpet.
Wash Tool
Suitable for use on upholstery
and carpeted stairs.
Perfect for reaching into crevices.
Always close the hose connection
port cover after using the hose.
The machine may lose suction if
it is not closed properly.
To Next Page
Loading...
