12
USING YOUR MACHINE
IMPORTANT: Always check the tools are clean and free from debris, don’t use if damaged, broken or worn.
Always switch OFF the machine before attaching the concentration tool and accessories.
Press the accessory release
button and lift the machine
to release the floorhead.
Twist the steam control dial
to the desired setting.
Hold the trigger in until
steam appears from the
nozzle. During use release
and squeeze the trigger
in short bursts. Don’t hold
the trigger continuously to
prevent over wetting.
Press the handle release
button and lift the handle
to remove.
Push the concentration
nozzle into the machine
until it clicks into place.
Plug into the mains and
turn the dial to 'ON'.
The red light will illuminate.
The machine will be ready
after approximately 30
seconds. During this time
there will be no sound
whilst it is heating up.
Using as a handheld
To Next Page
Loading...
Need help?
General
