8
CAUTION: The machine and accessories get very hot during use. Always allow them to cool down before handling.
Always switch off and unplug the machine when assembling or disassembling.
Always switch off the machine before emptying the water tank or changing the cloths/accessories.
PLEASE READ THE SAFETY PRECAUTIONS ON PAGES 2 & 3 BEFORE USE.
GETTING STARTED
Assembly
Push the handle into the
main body until it clicks
into place.
Push the main body down
into the floorhead until it
clicks into place.
IMPORTANT: Please refer to floor manufacturer’s care recommendations before use and test the machine on a hidden area of
flooring to begin with. Only suitable for use on sealed hard floors.
Test for colour fastness in a small hidden area of upholstery/fabric to check for colour removal before use.
When using the machine, basic safety precautions should always be observed.
Don’t aim the machine at people, animals, plants and electrical components or wires. Never touch the steam jet or floorhead from
a short distance (there is a risk of scalding).
The machine is equipped with a thermostat and a thermal cut-out. If for any reason the machine overheats it will switch off.
If this happens switch off and unplug the machine, allow to cool for at least 2 to 4 hours and re-try.
Don’t use hot or boiling water to fill or clean the water tank.
To Next Page
Loading...
Need help?
General
