Vax Careline: AU: 1300 361 505
NZ: 0800 800 900
vax.com.au
vax.co.nz
8
Maintenance
(Keep your Vax as good as new)
Storage
Installing and cleaning the DRY lter
Before storing away, make sure to empty all contents of tank container.
Make sure all parts, tank and lters are dry prior to storing machine.
NOTE: Unplug machine from the power outlet before performing maintenance.
Installing Dry Filter
1. Install the dry lter over the lter cage with the at end of the lter towards the vacuum power head. Carefully
push lter in until it stops against the power head. (g.1 & 2)
2. Place lter retainer on top of cartridge lter over the raise lip and tighten down by turning retainer clockwise,
do not over tighten. (g. 3 & 4)
Removing and Cleaning Dry Filter (THIS FILTER IS NOT WASHABLE)
1. Unlock and remove the lter retainer by turning retainer handle anticlockwise.
2. Carefully hold and pull the dry lter up for removal. (g.5)
3. Clean the cartridge lter by gently tapping or brushing dirt o. For optimal performance it is recommended
to regularly change this lter depending on level of use (eg. 3-6 months).
4. Install cleaned or new lter into place as instructed above.
To Next Page
Loading...
Need help?
General
