Assembling your wet & dry vacuum cleaner
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Getting started
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner when assembling.
Place the tank upside down
and rmly press the four
caster wheels into the base
of the tank.
Place the top motor housing
cover onto the main tank
and secure into position
with the retaining clips on
each side. Use the screws
provided to attach the
motor housing handle.
Attach the 3 piece wand
to the end of the hose and
then the dual function oor
tool to the end of the wand.
Push the exible hose
into the connector and twist
slightly clockwise.
To remove the exible hose,
twist house anticlockwise
and pull.
Use bristles on the oor
tool for hard surfaces.
For soft surfaces such as
carpet, remove bristles by
pressing the 2 clips down.
To Next Page
Loading...
