Using your machine
NOTE: The carpet washer should be in the upright position when using the hose or pre-treatment wand; de-activating the
SpinScrub brushes and brushbar.
Pre-treating your carpet before washing will help to remove stubborn stains. Do not saturate your carpet.
Using the pre-treatment wand
Pour required amount
of pre-treatment cleaning
solution into tank.
Tighten cap before
returning tank to unit.
Fill the clean water tank
with warm water
(max 40’C).
Turn wash/rinse
dial to ‘wash’.
Pull down accessory
hose connector cover.
Push wand connector
into solution tube port.
Plug into mains,
press the On/O
button to switch on.
Press and hold trigger
on pre-treatment wand,
spraying evenly over
stubborn stains.
15
Leave the solution for
10-15 minutes before
washing carpet.
To Next Page
Loading...
