Using your machine
Using the upholstery wash tool
NOTE: The carpet washer should be in the upright position when using the upholstery tool; de-activating the SpinScrub
brushes and brushbar.
Pour required amount
of carpet cleaning solution
into tank. Tighten cap
before returning tank to
unit.
Push hose end and hose
connector into hose and
solution connection port.
Fill the clean water tank
with warm water
(max 40’C).
Pull down accessory
hose connector cover.
Turn wash/rinse
dial to ‘wash’.
Plug into mains,
press the On/O
button to switch on.
Slide upholstery tool over tab at end of hose until it
clicks into place.
To Next Page
Loading...
