Vax W85-PP-T Dual Power Pro

Using your machine
Using the upholstery wash tool
NOTE: The carpet washer should be in the upright position when using the upholstery tool; de-activating the SpinScrub
brushes and brushbar.
Pour required amount of
carpet cleaning solution
into the clean water/
solution tank.
Push hose end and
hose solution connector
into hose and solution
connection port.
Fill the clean water/
solution tank with warm
water (max 40’C).
Pull down accessory hose
connector cover.
Turn wash/rinse dial
to ‘wash’.
Plug into mains,
press the On/O button
to switch on.
Slide upholstery tool over tab at end of hose until it
clicks into place.