Using your machine
Using the hose and SpinScrub tool
CAUTION: Test for colourfastness - Wet a white absorbent cloth with the solution. In a small hidden area of your carpet/
rugs/upholstery gently rub with the dampened cloth. Wait ten minutes and check for colour removal or bleed with a white
paper towel or cloth. If your carpet has more than one colour, check all colours.
Pour required amount of
carpet cleaning solution
into the clean water/
solution tank.
Press trigger on hose to
release solution/water.
Push hose end and
hose solution connector
into hose and solution
connection port.
Fill the clean water/
solution tank with warm
water (max 40’C).
Squeeze trigger on the
forward stroke, release
trigger on backward
stroke to recover
solution/water.
Slide SpinScrub tool over tab at end of hose until it
clicks into place.
Pull down accessory hose
connector cover.
Turn wash/rinse dial
to ‘wash’.
Plug into mains,
press the On/O button
to switch on.
TIP
Use the carpet washer
or hose to pick up spills
before washing and
cleaning the area.
To Next Page
Loading...
