Using your machine
NOTE: Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary to repeat
the cleaning process. Make crisscrossing strokes to the original pattern and overlap each pass.
Pour required amount of
carpet cleaning solution
into the clean water/
solution tank.
Press the recline
pedal and pull
handle backwards.
Fill the clean water/
solution tank with warm
water (max 40’C).
Squeeze the trigger to
release solution and
water mix.
Turn wash/rinse dial to
‘wash’. The SpinScrub
brushes and brushbar
deep clean your carpets
with water and solution
removing dirt and stains.
For best results apply
water/solution on the
forward stroke and
release the trigger to pick
up water/solution on the
backward stroke.
Plug into mains,
press the On/O button
to switch on.
Turn wash/rinse dial
to ‘rinse’. Only water
is released to remove
solution residue.
TIP
For best cleaning results use
slow straight parallel strokes.
Intermittent dry forward strokes
will increase water pick up.
The ‘rinse’ mode will also
work when using the hose.
To Next Page
Loading...
Need help?
General
