vc999 K5 - Program Table

55 pages

Save Page as PDF

To Next Page

To Previous Page

K5/K5N Vacuum Packaging Machine

Operation

2002-04-25 Art. no. 519.339 DE Page 36/55

9.5.7 Program table

Fig. 9/12

Main Page

Table of Contents2
Introduction5
General Information5
Definitions6
Protection of Copyright6
Safety, Warranty7
General Safety Instructions7
Use as Prescribed8
Machine Without an Inert Gas System (K5 Type)8
Machine with an Inert Gas System (K5N Type)8
Processing Materials9
Vacuum Bags9
Suitable Products9
Inert Gas9
Requirements for Operators10
Explanation of the Safety Instructions10
Warranty, Liability10
Description of the Machine11
Principle of How It Works11
Structure of the Machine11
Packaging Cycle11
Technical Data12
Dimensions12
Weight12
Vacuum Technology13
Vacuum Pump13
Vacuum Generation13
Welding Technology13
Inert Gas Connection13
Power Supply13
Controller14
Noise Emission14
Packaging and Transport15
Packaging the Machine15
Transportation of the Machine15
Unpacking the Machine15
Setting up the Machine16
Criteria for the Installation Site16
Foundations16
Ambient Temperature16
Safety Space16
Interface Definition17
Electrical Connection17
Inert Gas Connection17
Installation of the Machine18
Electrical Installation18
Inert Gas Installation19
Pouring in Oil19
Cleaning the Machine19
Start-Up20
Initial Start-Up20
Installation Check20
Switching on the Machine20
Operation22
General Instructions22
Requirements for Operation22
Preparation22
Preparing the Product22
Packaging Materials23
Preparing the Products for Packaging23
Adapting the Packaging Machine to Suit the Product24
Controls26
Control Panel26
Switching on28
Inserting Bags28
Starting the Packaging Cycle29
Intervention in the Packaging Cycle29
Ending Packaging29
Programming30
Packaging Programs30
Meaning of the Parameters30
Vacuuming to Evaporation Point (A)30
Vacuuming to the Setpoint (B)30
Vacuuming in Stages up to the Setpoint (C)31
Standby Vacuuming31
Intermediate Ventilation31
Welding31
Cutting32
Preventilation (Soft Air)32
Programming33
Selecting a Program Number33
Compiling or Changing a Program33
Program Overview34
Protected Programs35
Service Program35
Program Table36
Switching off the Machine37
Faults38
Displayed Faults38
Other Faults39
Process Oils40
Maintenance41
Cleaning41
Detergent41
Cleaning Interval41
Checks41
Maintenance and Servicing42
Replacing the Seal on the Lid42
Maintenance on the Welding Bars42
Maintenance of the Welding Cap Pass44
Maintenance Work on the Power Supply45
13.3.4.1 Electric Fuses45
13.3.4.2 Replacing the Electronics Board45
Maintenance of the Vacuum Pump46
13.3.5.1 Topping up Oil46
13.3.5.2 Oil Changes47
Repairs49
Spare Parts49
Ordering Spare Parts49
Disposal50
Diagrams51
Pneumatics Diagram51
Circuit Diagrams52
Index54

Related product manuals

vc999 K5 - Program Table

Table of Contents

Related product manuals