An error made in operation or in the connections is sometimes mistaken for a failure or
breakdown. Perform the checks described in the following table before calling a Service
Agency.
Symptom Cause Remedy
CD-Changer does not react. Improper connection. Check connections.
Blown fuse in the car. Replace with a fuse of
the correct type and
amperage (consult car radio
instructions).
If fuse blows again, consult
a Service Agency.
Software hang-up. Press Reset button.
Magazine cannot Direction in which it is Insert in correct direction.
be inserted. inserted is wrong. Pay attention to the printing
on the magazine.
CD is not played. Disc has been loaded upside Load disc with play side
down. facing upwards.
Large scratches on disc or Insert disc without scratches
warped disc. or which is not warped.
Noise is heard during Scratches on disc. Compare sound with
playback or sound is another disc. If sound from
intermittent. second disc is acceptable,
first disc is defective.
Extremely dirty disc. Clean disc.
Transport screws still Remove screws (x3) on
in place. bottom of unit and then use.
Setting mechanisms of shock Adjust setting mechanisms
absorbers are adjusted in in proper direction (refer
the wrong direction. to “Installation” in
Operating Instructions).
CD player does not function. If the weather is cold there Wait for about 5 minutes for
may be some condensation the moisture to evaporate.
on the laser.
If you cannot solve the problem and you still have to send your CD changer for service, always
send the complete set with magazine and the transport screws in place. Do not try to open
the changer to service it yourself.
CH0600/1000 GB 30/07/99 14:01 Page 9
To Next Page
Loading...
Need help?
General
