Vdwall LVP615 - Page 25

press OK to enter confirmation menu press OK to confirm( Note: the output
resolution you select must be bigger than the resolution of actual LED
screen or equal );
Setting output width and height
23.4. After opening processor press Setup key to enter setup menu, press Brt- to
select 1.Output Image, press OK to enter output image setup;
23.5. After entering output image setup menu, press Brt- or Brt+ key to select
setup option, rotate OK to change parameter value, then press OK to
confirm ( the output width and height must be as same as the width and
height of actual LED screen, out _H or _V start normally keep 0, change it
4. Output Image
--------------------------------------------------------------------
1.2 Resolution 1920 x 1080_60
1.2 Out Width 1920
1.3 Out Height 1080
1.4 Out H_Start 0
1.5 Out V_Start 0
1.6 Test Pattern Off
Tips
--------------------------------------------------------------------
Data will reset
Press < OK > to reset
Input： HDMI
In Status： 1080p
--------------------------------------------------------------------
Output Size： 1920 x 1080
Output Start： ( 0, 0 )
--------------------------------------------------------------------
Switch Mode： One Key SW.
Switch Time： 0 Sec
Setup
--------------------------------------------------------------------
1. Output Image >>
2. Input Video Signal >>
3. Text Overlay >>
4. Color & Brightness, etc. >>
5. Audio >>
6. Communication >>
7. 语言主/ Language >>
8. Advanced >>