Vdwall LVP615 - Page 26

means move the location of output video);
23.6. Please set the resolution of sending card as same as LVP615’s output
resolution, then configure sending card system ok, ( after configuring
sending card system ok, must set the X location of LED2’s sending card be
896, if no you only can get a half part of video, after setting you can get a
full video on LED screen );
PIP application example
23.7. For example we need the LED screen to display two video sources, it can be
different or not, and we need the two window size being 896x1024;
23.8. After opening LVP615 press On / Off key to open PIP / POP function, then
press signal key to select a video source for PIP / POP window;
5. Output Image
--------------------------------------------------------------------
1.2 Resolution 1920 x 1080_60
1.2 Out Width 1792
1.3 Out Height 1024
1.4 Out H_Start 0
1.5 Out V_Start 0
1.6 Test Pattern Off
Main Input： HDMI
Main In Status： 1080p
PIP Input: V1
PIP In Status:
--------------------------------------------------------------------
Main Output Size： 2048 X 1152
Main Output Start： (0, 0)
PIP Output Size： 682 x 384
PIP Output Start： ( 16, 16 )