Veco Frigoboat Capri 50F User Manual

19 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Frigoboat

Marine Refrigeration Systems

---------------------------------------------------------------

Installation & Instruction Manual

For All Models:

Air Cooled, Pumped-Water Cooled,

Keel Cooled, and Keel-plus-Air Cooled

(Systems using Secop (formally Danfoss) BD 35 or BD 50 compressors)

It is important to read this manual thoroughly before

installing and operating a Frigoboat system.

Veco NA

301.352.6962

info@veco-na.com

Rev 39 – 02/2019

Table of Contents

Questions and Answers:

D
Dillon GibsonAug 15, 2025
What to do if Veco Compressor attempts to start, then stops soon after?
- C
  Christopher BakerAug 15, 2025
  If your Veco Compressor starts and then stops, consider these potential causes: * **Power Supply**: The most likely cause is a faulty or inadequate power supply. Monitor the supply voltage at the controller's power terminals before, during, and after start attempts. It should not drop below threshold levels. Check the power supply, ground connections, wiring size and charge the batteries if necessary. * **Relay or Unauthorized Component**: A faulty fan or pump relay, or an unauthorized component, could be the issue. Remove the connectors from the F and + terminals on the controller and try restarting. Note the maximum current draw on these terminals is limited to 0.7 amps at 12v. * **Refrigerant Couplings**: Check that all refrigerant couplings are properly made.
M
Michael WardSep 2, 2025
How to prevent excessive frost build-up in my Veco Compressor system?
- R
  Richard MyersSep 2, 2025
  To prevent excessive frost build-up in your Veco Compressor system, ensure that: * All drains and holes in the box are sealed. * If using a circulating fan, it's not too powerful and doesn't force cold air out of the box. * Door/lid seals are in good condition. Replace if necessary. A good seal should grip a dollar bill when closed. Apply masking tape to suspect areas after defrosting and check for frost build-up after several days to identify leaks.

Veco Frigoboat Capri 50F Specifications

General

Refrigerant	R134a
Cooling Capacity	500 BTU/h
Voltage	12/24 V
Type	Reciprocating
Power	12/24 V

Summary

Chapter 1 Frigoboat Systems

Chapter 2 Paris 35F, Capri 35F, Capri 50F - Air cooled

Installation and Ventilation

Provides guidance on mounting and ensuring proper airflow for air-cooled units.

Chapter 3 W35F, W50F - Water cooled with pump

Mounting and Pump Setup

Details the placement of water-cooled units and the setup of the raw water pump.

Chapter 5 Danfoss/Secop Electronic Controller

Controller Specifications and Faults

Explains voltage requirements, compressor speeds, and diagnostic fault codes.

LED Alarm Indicator Guide

Details the function of the LED indicator and its blinking patterns for fault diagnosis.

Chapter 11 Troubleshooting Guide

Compressor Start-up Issues

Diagnoses and resolves problems related to the compressor not starting or attempting to start.

System Operation Problems

Addresses issues where the system starts but stops unexpectedly or runs too hot.

Box Temperature Control

Guides on troubleshooting high or low temperatures within the icebox.

Frost Build-up Issues

Related product manuals

Veco Frigoboat Capri 35F

Veco Frigoboat W35F

Veco Frigoboat K35F

Veco Frigoboat K50F

Veco Frigoboat Paris 35F