Veeder-Root EMR4 TLS-300 - User Manual

INSTALLATION and QUICK HELP
FOR TLS CONSOLE INTERFACE TO THE
VEEDER-ROOT EMR4 DATALINK
USING AN XTEND 900 MHZ WIRELESS MODEM
577014-353 Rev. A
Veeder - Root
Page 1 of 18
INTRODUCTION
This Installation and Quick Help Guide contains the necessary information to connect a wireless modem
to a TLS-300, TLS-350, TLS4, or TLS-450PLUS console and obtain the tank information in the DataLink
program on a PC.
DESCRIPTION:
Kit Number
Description
General Contents and Comments
0845900-037
TLS-3XX Consoles Interface Kit
- XTend 900 MHZ
This TLS kit includes:
• Wireless modem with standard antenna
• Special 9-pin connector for modem
• Special 25-pin connector for console
• 25-foot Ribbon cable for console to modem
connection
• Power supply for modem
• This manual
0845900-040
TLS-4XX Consoles Interface Kit
- XTend 900 MHZ
This TLS kit includes:
• Wireless modem with standard antenna
• 9-pin connectors for modem and console
• 25-foot ribbon cable for console to modem
connection
• Power supply for modem
• This manual
INDIVIDUAL MODEM UNIQUE ADDRESS - IMPORTANT
Each modem has a unique address assigned by Veeder-Root. This number is on the label on
the modem itself, and on the box. This number is your traceability from the TLS console to the
office software. The TLS connected modem number will be entered into the office software in
the TLS modem location on the DataLink configuration page.
TLS CONNECT KIT MODEM:

Veeder-Root EMR4 TLS-300 Specifications

General

Manufacturer	Veeder-Root
Compatibility	TLS-300
Device Type	Modem
Model	EMR4
Communication Protocol	V.34, V.32bis, V.22bis, V.22, V.21, Bell 212A, Bell 103

Summary

Modem Unique Address and Introduction

Individual Modem Unique Address

Explains the importance and location of the unique modem address for traceability.

XTend 900 MHz Modem Mounting and Connection

Modem DIP Switch Settings

Details the required DIP switch settings for the XTend modem.

Antenna and Serial Connection

Instructions for screwing the antenna and connecting the serial cable to the modem.

TLS Console Connection Types

TLS-300 Console Connection

Specifies the direct connect location and connector for TLS-300.

TLS-350 Console Connection

Identifies the RS-232 serial interface module and connector for TLS-350.

TLS4 Console Connection

Locates the 9-pin serial connectors on the TLS4 console.

TLS-450 PLUS Console Connection

Identifies an available 9-pin serial connector on TLS-450PLUS.

Console Setup and Security Configuration

Security Code and DIP Switch Settings

Guides on disabling front panel security and setting console DIP switches.

Serial Communications Protocol Setup

Configures serial communication parameters like baud rate, data bits, and parity.

Datalink Setup for TLS Console

Configuration Page Settings

Steps to select the modem and enter the TLS console modem number in DataLink.

Tank Page Data Viewing

Navigating the Tank Page to view detailed tank information and polling status.

Troubleshooting Modem Communication

Verifying Modem Online Status

Steps to check if the modem is online via the DataLink taskbar icon.

Troubleshooting Communication Errors

Identifies screens indicating communication errors or no answer from TLS.

Warranty, Approvals, and Claims

Modem Warranty and Regulatory Approvals

Information on modem warranties, regulatory approvals, and user guides.

Damage Claims and Return Shipping

Procedures for handling damaged merchandise and returning parts.