17
EMR
3
- Truck Installations
EMR4 Truck Installation IInstalling The Remote Display (Optional)
Figure 10. Remote Display Assembly
Figure 11 displays the wiring connections to a remote display.
Front View Rear View
Mounting bracket kit
(P/N 845900-024)
Plastic caps (remove
for cable entry)
These 2 hex head bolts are drilled
through for sealing the front cover
C&C switch
#30 Torx screws (4)
758-27.eps
#30 Torx screws (4) fasten into back of
Remote Display housing
Adjust mounting strips to desired
indents each side, then tighten nuts
Mounting Strips shown
in low position (2)
1 Nut and 1 lockwasher
each side
Base
Mounting Strips
shown in high
position
Assembly of Remote Display
Head Mounting Bracket
Side view
8.625"
(220 mm)
high position
or
6.625"
(168 mm)
low position
9.5"
(240 mm)
3.25"
(83 mm)
5.625"
(143 mm)
Remote Display Head
(P/N 84559X-002)
To Next Page
Loading...
