1
Introduction
This manual contains procedures for the installation or replacement of the following sensor interface modules:
• Veeder-Root Type A Interface Module
Part No. 329956-001 (with console)
• Veeder-Root Type B Interface Module
Part No. 329950-001 (with console)
• Veeder-Root Vapor Sensor Interface Module
Part No. 329357-001 (with console)
• Veeder-Root Groundwater Sensor Interface Module
Part No. 329399-001 (with console)
• Veeder-Root Interstitial Sensor Interface Module
Part No. 329358-001 (with console)
The above parts are for TLS 350 Series Consoles designed and manufactured by Veeder-Root. This manual
assumes all preliminary site preparation is completed, and that field wiring from the sensor junction box to the
console is in place.
Contractor Certification Requirements
Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
Level 1 Contractors holding valid Level 1 Certification are approved to perform wiring and conduit routing,
equipment mounting, probe and sensor installation, tank and line preparation, and line leak detector installation.
Level 2/3 Contractors holding valid Level 2 or 3 Certifications are approved to perform installation checkout,
startup, programming and operations training, troubleshooting and servicing for all Veeder-Root Tank Monitoring
Systems, including Line Leak Detection and associated accessories.
Warranty Registrations may only be submitted by selected distributors.
Related Manuals
If site preparation or field wiring is necessary, you must refer to the following manual for installation instructions:
576013-879 TLS-3XX Series Consoles Site Prep and Installation Manual
To Next Page
Loading...
