Veeder-Root TLS-450 Console Hardware Replacement

Replacing the Printer Door Assembly (P/N 330020-626) Before Turning Off Power
7
4. Disconnect the two cables from the Printer door (see Figure 3).
5. Remove the top and bottom #8 taptite screws in the Printer door hinges and remove the door.
6. Get the replacement Printer door and line up the holes in the two door hinges with the top and bottom holes
in the console housing and screw in the top and bottom #8 taptite screws. Tighten the two hinge screws.
7. Attach the grounding braid to the saddle clamp on the inside of the Printer door (see Figure 4).
8. Connect the USB cable and the power cable to the printer (see Figure 4).

Veeder-Root TLS-450 Specifications

General

Brand	Veeder-Root
Model	TLS-450
Category	Music Mixer
Language	English