Need help?Do you have a question about the Vega SOLITRAC 31 and is the answer not in the manual?
General| Material | Stainless Steel |
|---|---|
| Type | SOLITRAC 31 |
| Tracking Accuracy | ±1 mm |
| Application | Level measurement |
| Thread size | G 1½ A |
| Power Supply | 24 V DC |
| Operating Temperature | -40 ... 80 °C |
Explains the purpose and scope of the operating instructions manual for the user.
Identifies the intended audience as trained and qualified personnel.
Describes safety symbols, notes, and their meanings for safe operation.
Specifies that only trained and authorized personnel should perform operations.
Defines the sensor's intended function for continuous level measurement.
Highlights hazards and potential damage from improper product use.
Outlines general safety requirements and compliance with regulations.
States that the device meets legal EU directive requirements.
Lists compliance with relevant automation technology user association standards.
Provides region-specific installation compliance notes.
Guides users on environmental protection practices during use and disposal.
Details the information found on the instrument's type label for identification.
Explains the radiometric measurement technique used by the sensor.
Provides guidelines for handling the instrument during transit and storage.
Lists optional components available for the instrument.
Describes the prerequisite component for radiometric measurement setup.
Covers essential safety and handling precautions before mounting.
Provides specific guidance and requirements for installing the sensor.
Outlines safety steps and requirements before making electrical connections.
Details the wiring procedure for connecting the sensor for level measurement.
Describes wiring for instruments specifically for level detection applications.
Explains how to connect multiple instruments for cascaded measurements.
Guides on configuring the Profibus PA network address for the instrument.
Instructions for attaching and detaching the user interface module.
Explains the operation of the display and adjustment module interface and keys.
Details the process of configuring parameters for level measurement.
Configuration for secondary instruments in a summation setup.
Configuration for sensors used in point level detection applications.
Describes how to connect a PC to the sensor for configuration.
Outlines the steps for adjusting parameters using PACTware software.
Recommends and explains how to save configuration data.
Information on using Device Description files for adjustment.
Specifies minimal maintenance requirements for normal operation.
Explains how to interpret device status and diagnostic messages.
Provides a guide to troubleshooting and resolving instrument errors.
Details the procedure for replacing the device's electronics module.
Lists the components and procedure for updating the instrument's firmware.
Guides users on the process for sending the instrument for repair.
Provides instructions on how to safely remove the instrument.
Guides on environmentally sound disposal methods for the instrument.
Lists detailed specifications and performance data of the instrument.
Provides specific details for Profibus PA communication.
Shows physical measurements and mounting dimensions of the instrument.
Information regarding patents, trademarks, and intellectual property.
Lists the brands and company names used in the document.
To Next Page
