Remove the inlet water filter. Inlet water filter may be cleaned or replaced
with the new one. Do not use cutting and driller tools those may damage
the inlet water filter during the cleaning operation. After opening the water
valve, open the hot water tap and wait until achieving the regular water
flow. If the device does not operates to very low water pressure, you can
completely remove the flow limiter.
Place the inlet water filter again on the water inlet component and place
the stopped by rotating in its place. After opening the water valve, open the
hot water tap and wait until achieving the regular water flow. Then, open
and close the hot water tap for several times to clean the system and
device from air gaps those may occur.
For the Customer
Please read and consider safety warnings. Do not expose the device to
frost. Please express serial numbers located on the device information label
to our customer representative when you call customer services. You can
see this label within the removable cover at the front of the instant water
heater.
To Next Page
Loading...
