Operating the DAB unit
1. Mount the DAB unit on the dash board using the provided suction cup holder.
2. Connect one end of the USB power supply cable to the Micro USB socket on
DAB unit and the other end to the dual USB car charger. Plug the dual USB car
charger into the car 12V power socket.
3. Connect the supplied antenna to the antenna socket.
4. Press the VOL Knob to turn on the DAB+ unit, the LCD will display
‘Velex World DAB'. Use 'MODE' button to select DAB mode/Bluetooth/AUX in.
5. For the first time use, you need to scan all the local DAB+ channels by pressing
and holding TX/SCAN button for 3 seconds to activate Auto Scan. All available
DAB+ radio channels will be scanned and saved until another Auto Scan is
performed. During scanning, a percentage bar will be shown on the display to
indicate the progress and the total number of channels available will be
displayed.
6. Once scanning is complete, you can select any DAB+ radio channel in
sequence via short press CH- button.
To Next Page
Loading...