Need help?Do you have a question about the Velleman K8400 and is the answer not in the manual?
General| Nozzle width | 0.35 mm |
|---|---|
| Print technology | Fused Filament Fabrication (FFF) |
| Printing material | ABS, Polylactic acid (PLA) |
| Layer thickness (max) | 0.2 mm |
| Layer thickness (min) | 0.05 mm |
| Number of print heads | 2 |
| Number of printing colors | - |
| Maximum build size (WxDxH) | - mm |
| Filament thickness supported | 1.75 mm |
| Product color | Translucent |
| Viewing window | Yes |
| Display technology | LCD |
| Maximum print platform temperature | 270 °C |
| USB version | 2.0 |
| Ethernet LAN | No |
| Compatible memory cards | SD |
| AC input voltage | 100-240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 150 W |
| Storage temperature (T-T) | -10 - 40 °C |
| Bundled software | Modified Open Source Marlin 3D Printer |
Weight and Dimensions| Depth | 380 mm |
|---|---|
| Width | 360 mm |
| Height | 395 mm |
| Weight | 10000 g |
Solder resistors, zener diodes, FETs, and screw terminals onto the K8403 circuit board.
Attach headers to the motherboard and connect the assembled K8403 PCB for integration.
Attach clips, add double-sided tape, and prepare shrink tubes for LED strips.
Solder white cables to coloured cables and insulate with shrink tubes.
Attach LED strips underneath the top of the 3D printer.
Route the long cable down to the motherboard and connect leads in terminals.
Download and install the necessary firmware for the LED add-on.
Navigate the printer's menu to set LED color and effects.
Use M420 G-code commands to control LED colors and states.
To Next Page
