Vello BG-C12 - Mounting and Securing the Grip

into the compartment.
Pull the door’s release
latch down (2) and insert
the top of the door into
the compartment (3) as
indicated by the arrows.
Swing the door shut to
lock it in place.
5. Remove the protective
cap and connect the BG-
C12 grip to the camera,
while aligning the grip’s
mounting screw with the
camera’s tripod socket.
6. Rotate the attachment
wheel in the direction
shown by the arrow until
it is firmly tightened.
When removing the grip,
turn the camera power off,
remove batteries, and replace
protective contact cap.
1
2
3
7
OVERVIEW INTRODUCTION
ASSEMBLY