Velopex Intra-X - Page 12

Daylight Loader Installation (Cont.)
INSTALLATION
4 VELOPEX INTRA-X
User Guide
3 b .
WARNING: When removing the fixer
and developer modules, slide tanks
sideways until completely clear of the
immersion heaters mounted on the
machine internal wall.
Unscrew the two retaining screws
and remove white protective strip
from sealing material on the back
of the loader. Remove black covers
from the studs on the front panel.
Remove protective film from
viewing window cover.
4 .
5 .
6%,/0%8).42!8
5SER'UIDE
/0%2!4)/.

/PERATINGTHE0ROCESSOR
4HE6ELOPEXISEQUIPPEDWITH
AUTOMATICSTANDBYMODE4O
INITIATEPROCESSINGFEEDlLM
THROUGH%NTRY3LOT)FTHATFAILS
TOWORKSLIDElNGEROVER@25.
3ENSOR
4)0 4HETIMETAKENTOACHIEVETHE
CORRECTTEMPERATUREDEPENDSONTHE
ROOMTEMPERATUREUSUALLYMIN
7!2.).' "EFOREPLACINGIN
THEMACHINEINTRAORALlLMPACKETS
SHOULDBEWIPEDCLEANOFALLMOUTH
CONTAMINANTS

0LUGINELECTRICCORDANDSWITCH
ON4HEMACHINEWILLTHENRUN
THROUGHAHIGHSPEEDSTARTUP
CYCLEOFMINUTES
4)0 !FTERAPPROXTENMINUTESTHE
PROCESSORWILLGOINTO@STANDBYMODE
BYWHICHTIMETHECHEMICALSWILLHAVE
REACHEDTHEIRCORRECTTEMPERATURE
7!2.).' !LWAYSTURN
MAINSELECTRICITYSWITCHOFFATNIGHT
)NCORRECTTEMPERATUREISINDICATED
WHENTHEMESSAGEONTHE,%$
DISPLAYREADShT,Ov2EADYTOUSE
ISINDICATEDBYTHREEHORIZONTAL
CENTRALLINESANDCOOLINGDOWNIS
INDICATEDINTHELINESDESCENDING
FROMLEFTTORIGHT


)MAGEFORINSTRUCTION/.,9
6IEWING7INDOWISCLOSEDWHEN
OPERATINGMACHINE
)MAGESFORINSTRUCTION/.,9