Velopex Intra-X - Daylight Loader Installation

Daylight Loader Installation (if not installed)
INSTALLATION
VELOPEX INTRA-X 3
User Guide
(Images for instruction ONLY)
1.
Bring the Lid to the upright
position. When operating,
indication of the opened lid is
displayed as: “Lid”. Unscrew the
retaining screw at the back of
the machine above the plug and
lift the Display Panel.
Remove Side Panels by sliding
them Upwards in their runners.
Remove All Packing / Wrapping
Material and Modules.
TIP: Start with the Dryer Module,
then the Water Module followed by
the Fixer and Developer Modules.
Those should be removed by sliding
the tanks out.
2 .
3a.
6%,/0%8).42!8
5SER'UIDE
/0%2!4)/.

/PERATINGTHE0ROCESSOR
4HE6ELOPEXISEQUIPPEDWITH
AUTOMATICSTANDBYMODE4O
INITIATEPROCESSINGFEEDlLM
THROUGH%NTRY3LOT)FTHATFAILS
TOWORKSLIDElNGEROVER@25.
3ENSOR
4)0 4HETIMETAKENTOACHIEVETHE
CORRECTTEMPERATUREDEPENDSONTHE
ROOMTEMPERATUREUSUALLYMIN
7!2.).' "EFOREPLACINGIN
THEMACHINEINTRAORALlLMPACKETS
SHOULDBEWIPEDCLEANOFALLMOUTH
CONTAMINANTS

0LUGINELECTRICCORDANDSWITCH
ON4HEMACHINEWILLTHENRUN
THROUGHAHIGHSPEEDSTARTUP
CYCLEOFMINUTES
4)0 !FTERAPPROXTENMINUTESTHE
PROCESSORWILLGOINTO@STANDBYMODE
BYWHICHTIMETHECHEMICALSWILLHAVE
REACHEDTHEIRCORRECTTEMPERATURE
7!2.).' !LWAYSTURN
MAINSELECTRICITYSWITCHOFFATNIGHT
)NCORRECTTEMPERATUREISINDICATED
WHENTHEMESSAGEONTHE,%$
DISPLAYREADShT,Ov2EADYTOUSE
ISINDICATEDBYTHREEHORIZONTAL
CENTRALLINESANDCOOLINGDOWNIS
INDICATEDINTHELINESDESCENDING
FROMLEFTTORIGHT


)MAGEFORINSTRUCTION/.,9
6IEWING7INDOWISCLOSEDWHEN
OPERATINGMACHINE
)MAGESFORINSTRUCTION/.,9