Vemer ECO - Safety Warnings and Technical Specifications

- 14 -
Manual User ECO
English
During the installation and operation of the instrument, follow the
instructions below:
1) The instrument should be installed by qualified personnel
2) Do not power or connect the instrument if any part of it is damaged
3) Switch off the power supply while installing the instrument
4) Follow the connection diagrams in this manual and on the
instrument
• Display: LCD
•Programing: weekly/daily
•Precision: ± 0,5 °C
• Power supply: 2 alkaline 1,5 V AA batteries
• Autonomy: minimum 12 months with alkaline batteries 1800 mA/h (at 23 °C)
• Charge reserve: about 1 minute (to substitute batteries)
• Battery charge status control
• Output two-step relay load:
maximum 5(1)A 250 V AC
•Two temperatures “SUN” and “MOON” are adjustable by one-turn trimpot:
— “”6 °C ÷ 35 °C “comfort” adjustment
— “”6 °C ÷ 20 °C “saving” adjustment
• ON-OFF temperature regulation with 0.3 °C
differential (off while on SET)
•Week day display: Italian (English on request).
• Daily resolution: 1 hour (minimum interval between settings).
• Measured temperature display: 0 °C ÷ +37,7 °C
• Measured temperature resolution: 0,1 °C
• Measure refresh: 1/60 seconds
•Protection level: IP40
•Working temperature: 0 °C ÷ +50 °C
• Storage temperature: -10 °C ÷ + 65 °C
•Testing on each piece
TECHNICAL SPECIFICATIONS
SAFETY WARNINGS